Friction door stop

I got tired of my door moving so I made this. Once printed it's meant to have packaging tape wrapped around the outside so whatever material is used doesn't flake off or get damaged by rubbing on the carpet. The inside is wider than the door because you're supposed to put 1/8th inch by 2 inch foam insulation tape on the inside.

I printed mine with way too high infill but the thin arms are a bit weak so if I printed it again I would just do like 4-5 perimeters so the arms were solid and 10-20% infill with PLA

I wouldn't expect this to work for someone else without modification since the distance between the carpet and bottom of the door will vary a lot but it's easy enough to design. Just thought the idea and my implementation was worth sharing.