Thingiverse
Friction Weld Rod
door Made_by_C4D3
7
Downloads
13
Likes
0
Makes
PLA and CA glue are totally different
PLA soft and flexes
CA glue Hard and rigid
they make a ok Joint as long as nothing moves. a better joint weld it!
A Dremel makes a great friction welder but you need a short perfectly straight bit of 3mm filament.
but i only have curvy 1.75 mm I hear you say?
print a bunch of these
keep them at 50mm or less and check they are spinning stalely. speed about 3
By printing flat they are much stronger and forgiving
PLA soft and flexes
CA glue Hard and rigid
they make a ok Joint as long as nothing moves. a better joint weld it!
A Dremel makes a great friction welder but you need a short perfectly straight bit of 3mm filament.
but i only have curvy 1.75 mm I hear you say?
print a bunch of these
keep them at 50mm or less and check they are spinning stalely. speed about 3
By printing flat they are much stronger and forgiving
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!