Fridge Magnets

This is a sequence of fridge magnets with a recess formed in the back to accommodate a small magnet (10mm diameter, 2.6 mm depth - https://www.amazon.com/dp/B07D8QPG2Y)
The design is snug so no glue should be needed. The magnets can be inserted by placing inside the recess, and approximately securing in place, then placing on a surface (magnet side down), and applying pressure. This could be manual pressure, or with the assistance of a small hammer (with a protective flat surface between hammer and print).

All models can be printed recess-side down (using support). Some can be printed standing up (no support, but use of a raft or brim - gummy bear, Tardis, elephant, Totoro), though best results seem to be with models flat.

Updated 12/32/2023: Totoro and Tardis models scaled up slightly, magnet size still the same.