Slicer Discord
Fridge note holder – 3D-Druckmodell von MakerWorld MakerWorld
Other House Models

Fridge note holder

13 Downloads
9 Likes
7 Makes
Zum Modell
Make notes, take notes! Fridge magnet for 3 pens / markers and small paper sheets.Holes for 4x2mm magnets (4 of them).Dimensions: 104mmx83mmx3mm. and pen holders protrude 17mm. !!! I just ordered magnets yesterday, so I haven't yet tried if they fit well. I used 2-sided tape for the photos !!! I removed supports with small screwdriver, it took a little time, but wasn't that hard.This could be made easier with some adjustments, I'm sure. After removing supports from the clip, use sandpaper as shown in one photo to get the desired gap, so you can fit 1 piece of paper, or plenty of them :) EDIT: the hole diameters are too big for 4mmx2mm magnets to fit well! And too small for 6mmx2mm magnets. I will fix this in future, now I glued magnets to the holes. Cheers!
Kategorie
Other House Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen