Thingiverse
friendly solar lamp
von m03da
6
Downloads
8
Likes
0
Makes
# a mod for generic solar garden stake lanterns
One piece requires 3 legs, 1 hub and 1 light diffuser. Print the mechanical parts in black with 20% infill, no supports needed. The diffuser you can either print out of clear material and leave it as is, or print it in white in vase mode (spiralised outer contour) but keep in mind that the neck and bayonet mount need to be solid so increase initial layer count as necessary.
Fits 55mm dia lamps without modifications and should friction-fit together as long as your dimensional tolerances are good, otherwise CA or epoxy glue can be applied. Feel free to modify the included FreeCAD files to fit your particular lamp, don't forget to post a remix after.
Tested with ALIKE lamps from Jysk.
One piece requires 3 legs, 1 hub and 1 light diffuser. Print the mechanical parts in black with 20% infill, no supports needed. The diffuser you can either print out of clear material and leave it as is, or print it in white in vase mode (spiralised outer contour) but keep in mind that the neck and bayonet mount need to be solid so increase initial layer count as necessary.
Fits 55mm dia lamps without modifications and should friction-fit together as long as your dimensional tolerances are good, otherwise CA or epoxy glue can be applied. Feel free to modify the included FreeCAD files to fit your particular lamp, don't forget to post a remix after.
Tested with ALIKE lamps from Jysk.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!