MakerWorld
Hueforge & Lithophane
Zum Modell
Friendship
11
Downloads
10
Likes
5
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmSwap Instructions: Start with Black At layer #11 (0.96mm) swap to Red At layer #18 (1.52mm) swap to Yellow At layer #24 (2mm) swap to White ( I skipped my white part because I used creamy white instead of normal White.…So use normal vibrant white filament and yours will look much better than my photos :)))
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
