Slicer Discord
Frigidaire Refrigerator Handle Bracket – Modelo 3D imprimible de Thingiverse Thingiverse

Frigidaire Refrigerator Handle Bracket

por Mike7143
60 Descargas
53 Likes
4 Makes
Ver Modelo
Bracket to repair a broken refrigerator handle on a Frigidaire LFHT1817LW3. This is for the fridge handle, not the freezer handle. Requires cutting off an exact amount of the handle due to the spacers inside the cap part. Improves original design as it's thicker and has a hook to reach the far side in addition to the screws. See comments for other models it may fit based on user feedback!

From the top of the fridge door down to the top of the cut off fridge handle, that vertical distance needs to be 14.44 mm. At that distance, the handle will be fully seated in the cap, the bracket flush with the top of the fridge door, and the factory bottom mounting screw pulled up into the handle slot.

The bracket isn't perfect, the rotation of the handle profile is off a little so when installed, it's slightly twisted, but still works. The cap is also a very *very* tight fit on the handle, you may need to chamfer the edges of the handle and scrape bracket/handle as needed. I went with the ver
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

Mike7143 también publica en

1 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

4 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección