Fringe Twister

This is an almost completely printable four-threaded fringe twister with a gear ratio of 1:2 (rpm in:out). The largest part fits on a 120x120mm print bed.
Since you most likely have a larger print bed, you might want to check out [martinqr]s baseplate remix: https://www.thingiverse.com/thing:4797640

I tried printing the clamps at first, but they where too weak, so you can either try to design your own or you can use crocodile clamps (alligator clips?.. Krokodilklemmen in German ;-) .
To attach those, you have multiple options:
- glue them into the gear_small_w_hole.stl with epoxy or similar gluey stuff
- heat them up and melt them into the gear_small.stl (high infill)