Slicer Discord
Frisco Gravity Refill Pet Waterer replacement cap – Modelo 3D imprimible de Thingiverse Thingiverse

Frisco Gravity Refill Pet Waterer replacement cap

por Esq112358
3 Descargas
7 Likes
1 Makes
Ver Modelo
For a Frisco Gravity Refill Pet Waterer. You can buy a replacement cap for about $2. Reviews to the replacement cap said, and I paraphrase "the cost of the cap is about 1/2 when you including shipping" and "new cap and the threading barely worked."

on 11/29/2021 I revised to improve how water glugs up into the tank by inserting an air hole in the plug part. When I did this I revised the plug to come in two parts (three parts total).

70mm inner diameter. 15mm high inside. 17mm high outside. 78 outer diameter. Thread is a 3.6mm pitch.
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección