Slicer Discord
Frog M&M Dispenser – Modèle 3D imprimable de MakerWorld MakerWorld
Animals

Frog M&M Dispenser

78 Téléchargements
58 Likes
50 Makes
Voir le modèle
This M&M dispenser works for both mini and normal M&Ms, but it does not work for peanut or any other flavors. You need a little glue to assemble this frog. I used hot glue. the axles are made of filament allowing the device to rotate extruding the tongue. I printed this model in three different colors on three separate plates, but you can print it on one plate if desired. Assembly Guide Take a 3.75in (9.5cm) length of filament and thread the small arm pieces onto it then take a 1.5in (3cm) length and feed it through the tongue piece and both arm pieces, like is shown above. Hold onto this we will need it later.Use a little glue and insert the eyes into their respective sockets in the top jaw.Next add the bottom jaw and back throat pieces.Insert the rails into their slots in the bottom jaw. If they don't seem to fit snuggly add a little glue.Insert the tongue assembly from earlier and bend the filament into the holes in the side of both jaws, and glue them to the outsides of the top
Catégorie
Animals
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Post-traitement
Collage
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection