Thingiverse
Front Power Panel for 3D Printers
von faultedlogic
10
Downloads
6
Likes
0
Makes
This is a small panel I'd designed originally for relocating the power "on/off" switch to the front of my CTC A10S "CR-10 knockoff", and for adding a LED volt meter for monitoring power supply voltage. I liked this design well enough that I used it on my Anet A8 Plus as well.
Recently, I opted to add a provision for the LED volt meter on my original Anet A8's front mounted power switch housing and noticed that I never uploaded the design I made for the CTC. I'm just now getting around to uploading it.
This model attaches, or is at least intended to attach to the front of a 20x20 aluminum extruded printer frame with two M4 screws and T-Nuts. Be advised that this model requires 28mm of clearance between the bottom of the frame to which it is mounted, and the surface the printer resides upon. When I installed this model on my CTC A10S, I'd already raised the printer for stand-alone conversion by adding 23mm tall extensions between the feet and the frame. My Anet A8 Plus came wi
Recently, I opted to add a provision for the LED volt meter on my original Anet A8's front mounted power switch housing and noticed that I never uploaded the design I made for the CTC. I'm just now getting around to uploading it.
This model attaches, or is at least intended to attach to the front of a 20x20 aluminum extruded printer frame with two M4 screws and T-Nuts. Be advised that this model requires 28mm of clearance between the bottom of the frame to which it is mounted, and the surface the printer resides upon. When I installed this model on my CTC A10S, I'd already raised the printer for stand-alone conversion by adding 23mm tall extensions between the feet and the frame. My Anet A8 Plus came wi
faultedlogic veröffentlicht auch auf
284 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
