Thingiverse
Front Wheel Riser with 3 levels
door CrankyBob
1
Downloads
3
Likes
0
Makes
If you're going to be climbing a lot in Zwift, this riser allows you to raise the front wheel to simulate climbing to a limited degree.
The riser has three levels: 20mm, 40mm and 60mm
I designed the riser with a max tyre width of 28mm.
Print without a skirt or brim if possible as it will occupy all of a build plate of 220mm x 220mm.
NB: Estimated print time at 20% infill is some 36 hours! The print will use around 600gms of PLA filament.
The riser has three levels: 20mm, 40mm and 60mm
I designed the riser with a max tyre width of 28mm.
Print without a skirt or brim if possible as it will occupy all of a build plate of 220mm x 220mm.
NB: Estimated print time at 20% infill is some 36 hours! The print will use around 600gms of PLA filament.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
