Slicer Discord
Frosthaven Trapper Traps – 3D-printbaar model van MakerWorld MakerWorld
Other Miniatures

Frosthaven Trapper Traps

10 Downloads
3 Likes
6 Makes
Model downloaden
The Trapper's traps in Frosthaven can have many different effects. These magnetically connecting traps should help with that. The base rotates to indicate the heal/damage value and you can stack as many status effect hands on top as you like.Note: I intentionally did not add muddle, since that's only available at level 7 (which I never play to) as it just made the symbols too small (IMHO). If people would like me to add it, ask and I will make a top design for it. :-)Assembly:I used 3x1mm magnets which I got in a pack of 300 for ~$15CAD on amazon.Adjust the magnet diameter until you get a nice snug push fit.I printed the art work on normal 100gsm paper, then glued it on with Rubber Cement. I found that Rubber Cement is good for not bleeding through the paper and gives a good hold with both the plastic and paper.Optionally, you can spray on a clear coat to seal everything. I did not do this as I wanted the magnets to have as little between them as possible.
Categorie
Other Miniatures
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
supports nodig
Eendelig Supports vereist Hardware nodig
Supports 2/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

James publiceert ook op

254 extra modellen op 4 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Trends ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie