Frostpunk Dreadnought

My take on the Frostpunk Dreadnought, to be used with the board game once it comes out next year.

It's loosely based on the Dreadnought pictures and just made by hand/eye, no measuring, so it's around the right size - don't expect an exact copy. It was designed to be a bit bigger than 2 tiles - if you would like it bigger, just increase the size to 110/120/etc. % in your favorite slicing software.
One model is tilted 10 degrees, to simulate sinking into the ground - while it prints pretty well, there are some pieces that will be a bit rough - which is fine with me because it's supposed to old, busted and rusted. You can add snow to it later, around the base, etc.

I've also included two upright versions. One includes some passenger cabs.

There are two versions of each model included, one with supports and one without. Use of a brim is recommended.

Tip: I've discovered that if you paint PLA with Gorilla original clear glue, it fills in the layer lines. Prime/paint it,