Slicer Discord
Frother stand – 3D-Druckmodell von MakerWorld MakerWorld
Other House Models

Frother stand

164 Downloads
28 Likes
131 Makes
Zum Modell
I designed this stand to hold a frother. The top of the stand is supporting the frother allowing for the bottom whisk portion to float without contacting the stand's walls or bottom. To make sure yours fits; the hole in the center from the top of the stand to the bottom measures 140mm deep, with a diameter of 28mm. By scaling the model in a slicer the stand should be able to accommodate a variety of sizes There is a drainage hole at the bottom of the stand as well as channels to help keep the stand in place if it happens to get wet or is placed on a wet countertop. Supports are not needed for this stand. But I do recommend printing this standing upright as it normally would sit due to the drain channels on the bottom
Kategorie
Other House Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen