Thingiverse
Frsky Antenna Mount
por agrath
65
Descargas
32
Likes
0
Makes
I tried to print a few of the antenna mounts on here but couldn't get any to print successfully.
This one prints without support material (recommended without) and has two holes at 45 degrees that fits standard antenna tube that you can pick up from your LHS.
Fits the dr8-xp and v8fr-ii receivers and probably others too but I haven't tested with those (I have the two listed).
This one prints without support material (recommended without) and has two holes at 45 degrees that fits standard antenna tube that you can pick up from your LHS.
Fits the dr8-xp and v8fr-ii receivers and probably others too but I haven't tested with those (I have the two listed).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!