Thingiverse
FT-5 CANOPY FRAME AND SPOOL MOUNT
von Tripnutz
122
Downloads
59
Likes
1
Makes
A canopy , or roof system , for Folgertech FT-5 3D Printer. My main purpose for the design was to get rid of the cable chains and have a place for the wire loom to drop in from around center. Also, was hoping to have an easier time fully enclosing the machine to run ABS. Then I created the arm brackets which turned into multi purpose spool holders. The spool holder brackets can be used in a number of ways. You can just drop in a 5/16 threaded rod across them. You can add 608 bearing to the threaded rod and press them into the cutouts. You can just hang the spool directly from the arms. In a few pics attached I used Ramons universal spool holders on the 5/16 threaded rod.
You do not need to print with any supports. You do need a few items though.
BOM
24 - 5mm x 10mm screws
24 - 5mm Twist N Lock nuts
4 - 9" long pieces of 2020 extrusion
2 - 5" long pieces of 2020 extrusion
2 - 6.875" long pieces of 2020 extrusion
Spool Rod
1- 16" long 5/16-18 threaded rod
2 - 5/1
You do not need to print with any supports. You do need a few items though.
BOM
24 - 5mm x 10mm screws
24 - 5mm Twist N Lock nuts
4 - 9" long pieces of 2020 extrusion
2 - 5" long pieces of 2020 extrusion
2 - 6.875" long pieces of 2020 extrusion
Spool Rod
1- 16" long 5/16-18 threaded rod
2 - 5/1
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
