Thingiverse
FT-70D battery case
by D3V1N
14
Downloads
10
Likes
0
Makes
Yaesu FT-70D battery case made to fit 18650s and BMS board.
A 10k ohm thermistor to ground is needed for the center contact for the FT-70Ds onboard charger to work. The fit in the battery case it self is very tight and may need to be modified to fit needs. I used cut down nickle spot weld battery tabs to use as contacts. After placing contacts I suggest using epoxy on the inside to prevent short. I suggest the use of a BMS with 18650s due to the way 18650s fail. I will be using pre tabbed 18650s to save space and I don't have a spot welder.
A 10k ohm thermistor to ground is needed for the center contact for the FT-70Ds onboard charger to work. The fit in the battery case it self is very tight and may need to be modified to fit needs. I used cut down nickle spot weld battery tabs to use as contacts. After placing contacts I suggest using epoxy on the inside to prevent short. I suggest the use of a BMS with 18650s due to the way 18650s fail. I will be using pre tabbed 18650s to save space and I don't have a spot welder.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!