FT A-10

List of the setting i used for my parts.
canopy 1 point front and back
Print Canopy as a plug, Pint it standing on end in Spiralize mode, .4mm When its done you can fill it with plaster of pairs and glue the two half's together.
Grab a large pop bottle and heat shrink the bottle over the plug,

Cockpit and ejection seat
Must scale this up to 1.1 of normal size to print right Defualt size is a bit small.
Print upright .4mm 15% infill normal print with supports everywhere. will be some cleaning but worth it.

EDF pods , front , back , middle
Print .4mm Spiralize mode simple.

Edf Pod Inner
Print Spiralize mode but after design found need to scale down re scale it to .996 of original size before print and it will slide right in perfectly.

EDF fan Holder
Flip 180 deg and print on its face with the 4 feet up right.
15% infill

Tail exaust
make sure top fill bottom fill is on and set to 1mm base thickness. then print as Spiralize .4mm

EDF 28 blade fan
print at 1