FT Flyer Motor mount

SummaryUPDATE: after a few flights with a few hard landings(crashes) it finally broke the top off where the 2 skewers slide into the motor pod, this didnt stop the flying for the day cause i was able to pull the rubber bands over the skewers an it held them in place but i decided to re enforce the original design so i added alittle more material above the holes an some braces on the side, i have it printing right now so ive not got to try v2 my self just yet but i cant see any of the changes i made interfering with anything on the plane. hope this helps an enjoy. again any suggestions are appreciated.ive been messing with the flight test plane for the past month an i dont have away of cutting out the motors firewall out an attaching it other than print them an when trying to hot glue them they never stick to the hotglue an i found that i could use super glue to glue the firewalls to the hot glue but was still not happy with that so ive been take an making these that are pretty much jus