FT Goblin Parts

These are some parts I modeled for use with the [FT Goblin](https://store.flitetest.com/flite-test-goblin-electric-airplane-kit-760mm-flt-1059/p792313).

There are two versions of the firewall, one for motors with 16mm spacing for their screws and one for motors that have 16mm spacing for one pair of screws and 19mm for the other. My DYS motor uses 16x16, while a Racerstar I have uses 19x16. If your motor has different spacing this is easy to modify in the SCAD file by using the screw_spacing_h and screw_spacing_v parameters to the firewall module.

My previous camera mount was almost directly modeled off of the balsa version, just 3D printed as a solid piece. After a tree jumped out in front of where I was flying I redesigning the camera mount into a two piece system. Now the base can be hot glued into the body and the front part of the mount can be attached with M3 screws. If the camera mount is damaged you can simply print the front half again and swap to the new one without hav