FT Mini Arrow Canopy Hatch

I needed extra space in my mini arrow and didn't want to print out an entire new electronics pod, and this gives you an extra 5mm of clearance vs the foam board canopy. after you print it out heat it up until the ABS/PLA is floppy then mold it directly over the electronics bay. You really only need to secure the top section because once it is molded to you plane the bottom will hold in place without needing anything. You could velcro the bottom section if you feel it is necessary.

the picture is from my first version, which worked fine, and as you can see handled several very hard crashes. This is version 2 and should be quite a bit better.