Thingiverse
FT Mini Arrow Powerpod
by leonnimi
15
Downloads
3
Likes
0
Makes
I designed this thing as a replacement for the foamboard power pot for the FlightTest mini arrow. After some not so soft landings, the foam begun to disintegrate.
To ensure a good and stronger replacement, I added small wing-spars, which fit nicely into the existing ones, therefor making the plane very durable (tested by myself :D).
In the back is a motor-mount for many brushless motors. It might make sense to make this section modular, so that in the event of a crash and following damaging of the motor mount you do not have to replace the whole print. (it took ~3h with 0.3mm and high speed-printing 80mm/s).
The front section houses my rather large FPV-Camera, you might have to edit this for your equipment.
I used an 850 mAh 3S LiPo battery pack. CG seems fine. In the back is space for the esc and even a flight stabiliser (Aura 5 from FT). FPV gear, receiver... can be mounted inside the wing through holes in the design.
The whole things pressfits into the foamwings and should
To ensure a good and stronger replacement, I added small wing-spars, which fit nicely into the existing ones, therefor making the plane very durable (tested by myself :D).
In the back is a motor-mount for many brushless motors. It might make sense to make this section modular, so that in the event of a crash and following damaging of the motor mount you do not have to replace the whole print. (it took ~3h with 0.3mm and high speed-printing 80mm/s).
The front section houses my rather large FPV-Camera, you might have to edit this for your equipment.
I used an 850 mAh 3S LiPo battery pack. CG seems fine. In the back is space for the esc and even a flight stabiliser (Aura 5 from FT). FPV gear, receiver... can be mounted inside the wing through holes in the design.
The whole things pressfits into the foamwings and should
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
