Thingiverse
FT Mini Firewall
por MikeTitor
53
Descargas
45
Likes
0
Makes
Yet another Flite Test Mini Firewall. Use in place of the plywood firewall Flite Test designs call for.
Intended for brushless electric motors. Probably not suitable for gas engines.
Note: I model knowing the limitations of my 3D printer. Its old and has a few minor quirks. In general its accurate but holes especially tend to print out smaller than they are sized in the model. As such I model holes slightly larger to accommodate this. Test print any part and make sure any attached hardware like wire or skewers fit properly before bulk printing.
Intended for brushless electric motors. Probably not suitable for gas engines.
Note: I model knowing the limitations of my 3D printer. Its old and has a few minor quirks. In general its accurate but holes especially tend to print out smaller than they are sized in the model. As such I model holes slightly larger to accommodate this. Test print any part and make sure any attached hardware like wire or skewers fit properly before bulk printing.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
