Thingiverse
FT Mini Power Pod (MT1806)
por 4iqvmk
119
Descargas
73
Likes
2
Makes
Flite Test Mini Power Pod for the Power Pack A components
* 12x16 mm hole pattern for an Emax MT1806 motor
* Dovetail joints at the seams
* Designed to be printed flat and then glued
* Printing flat allows layer orientation to optimize strength
* Left and Right side frames are identical, other than flipped orientation
* 3 degree right and 0 degree thrustline offset options - only the firewall changes
* No supports required
Update 1 - 7/29/2018
* Added Firewall_1806_shift.stl, which shifts the hole pattern 1 mm to the left, compensating for the right thrustline angle. This should keep the prop hub more centered on the fuselage.
Update 2 - 7/29/2018
* Added dimensioned drawing
Update 3 - 8/10/2018
* Added Firewall_1806_straight.stl, which has zero thrust angle.
* 12x16 mm hole pattern for an Emax MT1806 motor
* Dovetail joints at the seams
* Designed to be printed flat and then glued
* Printing flat allows layer orientation to optimize strength
* Left and Right side frames are identical, other than flipped orientation
* 3 degree right and 0 degree thrustline offset options - only the firewall changes
* No supports required
Update 1 - 7/29/2018
* Added Firewall_1806_shift.stl, which shifts the hole pattern 1 mm to the left, compensating for the right thrustline angle. This should keep the prop hub more centered on the fuselage.
Update 2 - 7/29/2018
* Added dimensioned drawing
Update 3 - 8/10/2018
* Added Firewall_1806_straight.stl, which has zero thrust angle.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!