MakerWorld
Hueforge & Lithophane
Zum Modell
fubuki
1
Downloads
3
Likes
0
Makes
Project: fubuki 6!.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x269.49mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 1.9mmFilaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Tough Pine Green Transmission Distance: 1.5 PLA PolyLite White Transmission Distance: 5This print uses 3 unique filamentsSwap Instructions: Start with Black At layer #10 (0.88mm) swap to Pine Green At layer #13 (1.12mm) swap to White for the rest. Boost Meboost plz also send any request =)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
