MakerWorld
Hueforge & Lithophane
Go to Model
fubuki
3
Downloads
8
Likes
1
Makes
Project: fubuki 7!.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x343.85mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 1.8mmFilaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Tough Pine Green Transmission Distance: 1.5 PLA PolyLite White Transmission Distance: 5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #10 (0.88mm) swap to Red At layer #11 (0.96mm) swap to Pine Green At layer #15 (1.28mm) swap to White for the rest.Boost Meboost plz and send any request =)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
