MakerWorld
Hueforge & Lithophane
Go to Model
fubuki
4
Downloads
7
Likes
0
Makes
Project: fubuki 13!.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x357.39mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mmFilaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Tough Pine Green Transmission Distance: 1.5 PLA BambuLab Basic Orange Transmission Distance: 5 PLA PolyLite White Transmission Distance: 5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #9 (0.8mm) swap to Pine Green At layer #15 (1.28mm) swap to Orange At layer #19 (1.6mm) swap to White for the rest.Boost Meboost plz also send any request =)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
