fuel cell box

took the basic box and remixed it with another project box a friend was designing but couldnt get to fit properly. im very new to cad so this was all done in mesh mixer with added parts from my friends build along with a wall piece to act as a wire baffle on the side from another box.
hope everyone likes this and find it useful

** edit **
After first print of the top cell had failed because of too much retraction, I turned down my retraction by .5mms
After second print it was a success, although the small bolts around the gas cap were too small and didn't really stick due to so many retracts..
Same with the smaller hose nozzles on the sides of the cap where they were weakened as well.
Going to be adjusting the sizes of those parts later unless someone else would update it before myself.

Will need filing.