Fuel Line Holders

These are fuel line supports/holders designed for my 120" TBM. They use rubber grommets, note the vent line holder uses a larger diameter grommet for sliding through easier.

Fuel line stand is about 30mm high, has a couple holes on the bottom for screws if you want, 3/8" hole for a rubber grommet with a 1/4" hole for your fuel line

Canted 3-line holder has about a 15-20degree angle to correctly direct the fuel lines where they are going.

The vent line holder has a 7/16" hole for a 0.33" hole for the fuel line so slide through extra easy. It's purpose is to support the line and prevent your fuel dot from popping out.