Thingiverse
Full Height Headphonestand
von LordJepeto
229
Downloads
222
Likes
1
Makes
#Yet another Headphone Stand
I designed this, because I wanted a Headphone Stand that could be printed in one piece, yet accommodate larger Headphones.
It is designed to be printed standing, so I can make use of the available height of the Creality Ender 5. I printed with 20% infill and it seems to be plenty strong. Note, that with a height of 240mm it might not fit your Printer.
I tested:
* Hifiman Sundara
* Sennheiser HD600
* Fidelio Kopfhörer X2HR
They all fit really nice, except for the HD600, where setting it down can be a bit fiddly because of the top padding.
Some of the design is inspired by this Headphonestand for the Sennheiser HD800S on Printables : https://www.printables.com/model/428406-sennheiser-hd800s-headphone-stand
I designed this, because I wanted a Headphone Stand that could be printed in one piece, yet accommodate larger Headphones.
It is designed to be printed standing, so I can make use of the available height of the Creality Ender 5. I printed with 20% infill and it seems to be plenty strong. Note, that with a height of 240mm it might not fit your Printer.
I tested:
* Hifiman Sundara
* Sennheiser HD600
* Fidelio Kopfhörer X2HR
They all fit really nice, except for the HD600, where setting it down can be a bit fiddly because of the top padding.
Some of the design is inspired by this Headphonestand for the Sennheiser HD800S on Printables : https://www.printables.com/model/428406-sennheiser-hd800s-headphone-stand
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
