Fully 3D Printed RC Plane

Hey all,
This is a R/C Plane designed in Fusion 360.
I haven't had the time to print all of the components out so if you print and fly it please post your results :)
Recommended Equipment:
Hitec Feather Servos
2000-2500 kv miniquad motor with 5-6 in. propeller
A matching ESC and 3s(you don't want too much speed) LiPo pack
Tx/Rx Pair(min. 3ch) capable of Elevon mixing
Good quality Control Horns(I will design some)
Note: I wouldn't recommend this as a first plane-it doesn't look like it will be light or slow...

CG should be about 140mm from the front of the plane.

Happy Flying!