Fully 3D printed Speaker V10

This is the basic components of a 3D printed speaker; you need to add magnets and copper wire.

The Surround should be printed in TPU or this speaker may not work. I used 90A but it should work with everything from 85A-97A it will just change the frequency response (higher shore hardness = high frequency response-- 85A will act like a small woofer and 97A should act like a mid)

Magnets are as follows(Only need 1)



Large Neo Setup (Best Sounding-Most expensive)

-6-6.35x6.35x12.7mm-Square-N52

-9-9.5x9.5 mm- Round Magnets-N52



3 Large Neo Magnet-(Middle Ground)

3-30x2.8mm-round



small rectangle magnet array (worst sounding-least expensive)

38-19x4.5x2mm magnets



Copper wire is magnet wire with a .3 mm OD i used enough to set it up at 4.2OHMs you'll have to check your manufacture spec of wire for OHM per 1000 ft and then do some conversion math to get your desired OHM rating. I Also used a coil winder to get a smoother and cleaner coil wrapping,