Thingiverse
FULLY FOLDABLE TABLET HOLDER
door Jankoly
28
Downloads
12
Likes
0
Makes
Hi.
This is a holder for tablets of all sizes, in the pictured is holding a 13-inch iPad for comparison. A while ago I wanted to design one for when you travel, so I wanted it to be foldable.
This is my first prototype so I have not made any improvements.
advantage:
1. is printed on one piece
2. no assembly required.
3. fully foldable.
Tips: My copy is printed without brim and it was very easy to fold the parts. If your bed does not have good adhesion you have to use brim, in that case you may have to work a little to detach the affected parts.
post your makes
well, enjoy it and send me a photo of your result.
This is a holder for tablets of all sizes, in the pictured is holding a 13-inch iPad for comparison. A while ago I wanted to design one for when you travel, so I wanted it to be foldable.
This is my first prototype so I have not made any improvements.
advantage:
1. is printed on one piece
2. no assembly required.
3. fully foldable.
Tips: My copy is printed without brim and it was very easy to fold the parts. If your bed does not have good adhesion you have to use brim, in that case you may have to work a little to detach the affected parts.
post your makes
well, enjoy it and send me a photo of your result.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
