Fully Parameterizable Cup for Powders

A fully parameterizable cup I designed to get the correct amount of laundry detergent every time. In the default configuration the indents are at about 40mL and about 65mL respectively. You can calculate the volume as follows: CylinderWidth x CylinderHeight - (CornerRounding x CornerRounding) x (4 - π) x CylinderHeight For the default configuration that leaves you with 36.25mm x 36.25mm - (10mm x 10mm) x (4 - π) x 50mm = 65270mm3 = 65.27mL If you set CylinderBonusHeight to a non-zero value you'll have to add that to CylinderHeight when calculating the colume. This is not meant to be used with food items as the tiny imperfections make 3D prints near impossible to properly clean for the use with food.