Thingiverse
Fully printable PCB vise
por sneakypoo
13.3k
Descargas
10.1k
Likes
157
Makes
Pretty self explanatory, it's a vise to hold PCBs steady when you are soldering your components.
The ball joint design gives you a fair bit of movement to position your work where it is most comfortable.
The main drive screw has reverse threads on one side to make the jaws clamp your PCB right in the middle of the vise.
The base has a few square holes for magnets to keep it steady on your workbench.
The vise can hold PCBs with a maximum width of 10cm.
The ball joint design gives you a fair bit of movement to position your work where it is most comfortable.
The main drive screw has reverse threads on one side to make the jaws clamp your PCB right in the middle of the vise.
The base has a few square holes for magnets to keep it steady on your workbench.
The vise can hold PCBs with a maximum width of 10cm.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
