Thingiverse
(Fully printed*) Gamepad
door eemanon
5
Downloads
7
Likes
0
Makes
Version I of a retro gamepad. Basically, it's a "button study" to see what is possible to realize with PLA.
So I developped this as an easy way to have many (cheap) controllers for decent multiplayer of retro games programmed on my raspberry pi.
You may need some (I recommend hot) glue to hold the springs in place and stop the wires from moving and cables. For the circuit you need some 10k Ohm resistors (and some 1k Ohm resistors for gpio in protection)
*the wires can't be printed (yet)
So I developped this as an easy way to have many (cheap) controllers for decent multiplayer of retro games programmed on my raspberry pi.
You may need some (I recommend hot) glue to hold the springs in place and stop the wires from moving and cables. For the circuit you need some 10k Ohm resistors (and some 1k Ohm resistors for gpio in protection)
*the wires can't be printed (yet)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!