Slicer Discord
Fume filter for 3D printers – 3D-Druckmodell von Thingiverse Thingiverse

Fume filter for 3D printers

29 Downloads
16 Likes
1 Makes
Zum Modell
Absorbs nasties when printing ABS.

This is a holder to allow pieces of activated carbon filter foam to be held against the inlet of a small centrifugal blower (BFB0712H). Install inside the enclosure of a 3D printer to absorb microfine particles and VOCs when printing ABS.

This is simply recirculating air within the enclosure, rather than venting outside. Since ABS needs a warm enclosure, this keeps the heat in.

You can attach the whole assembly to the inside of the enclosure with M4 bolts.

I used 2 layers of the following filter foam. The "template" file allows you to easily cut the correct size circles with a hobby knife. When you start to notice an ABS printing smell again, replace the filter pieces.

https://www.aliexpress.com/item/32948431743.html
https://www.aliexpress.com/item/2-Black-activated-carbon-filtration-Foam-Sponge-Air-Filter-Pad-Square-13X13cm-HG5355X2/32811557292.html
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS
Ca. Druckzeit
12 h
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen