Thingiverse
Funbot hotend mount no sensor
door b3n3d1k7
1
Downloads
0
Likes
0
Makes
Just some slight improvements of the hotend mount.
Closed the holes for the nuts on the bottom - this makes it a lot easier to disassemble/assemble the hotend on the printer - e.g. for maintenance - as the nuts dont fall out all the time.
Also reduced the size of the base a bit.
Closed the holes for the nuts on the bottom - this makes it a lot easier to disassemble/assemble the hotend on the printer - e.g. for maintenance - as the nuts dont fall out all the time.
Also reduced the size of the base a bit.
b3n3d1k7 publiceert ook op
50 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!