Funcopter Tail Boom Upgrade

These parts are to swap the stock aluminum tail boom with a carbon fiber tube. My tube was 12mm OD and 10mm ID. Cut to same length as stock boom.

This slides on the outside of the tail boom to hold the servo push rod. Print 1 (Front)
FunCopterFrontBoomPushRodHolder.stl


This slides on the outside of the tail boom to hold the servo push rod. Print 1 (Rear)
FunCopterRearBoomPushRodHolder.stl


These slide inside your carbon fiber boom to hold the torque tube in the center. Print 4 (distribute them equally inside the tail boom) Oil.
FuncopterTrqTubeInsert.stl

These Plug into each end of the new boom. Print 2 (I glued the tail end that goes on the tail side to make sure it wouldn't get stuck in the tail section)
Funcopter round tube converter Simple.stl

Drill the holes out of the parts to make more space for the torque tube. You will continue to use the stock torque tube and gears. You will have to drill 2 small holes in the new boom in the same places as the o