Thingiverse
Funcub tail wheel holder
von odwquad
65
Downloads
41
Likes
1
Makes
This is a tail wheel holder for the MULTIPLEX FunCub RC Aircraft.
I had the problem, that the original tail wheel holder was to instable and I could not steering the airplane on the ground very good. So I printed this new holder and glue it on the yaw rudder.
The new holder have a 1,5mm hole for a wire to fix the wheel in it.
I had the problem, that the original tail wheel holder was to instable and I could not steering the airplane on the ground very good. So I printed this new holder and glue it on the yaw rudder.
The new holder have a 1,5mm hole for a wire to fix the wheel in it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
