Thingiverse
Funjet 2 Ultra Removable Electronics tray
von b14ckyy
6
Downloads
3
Likes
0
Makes
Simple Tray to house all the electronics for a Funjet 2 with FC setup.
The tray clips strongly under the carbon spar and is removable anytime. Make sure the ESC wires are long enough to reach when replacing motors ore removing the tray.
Keep in mind that having all electronics so close to each other needs proper GPS to work like M8Q or M8N and also should use 2.4GHz system to not interfere with digital servos like 900MHz systems do. FPV antenna is just mounted directly and stays in the fuselage for no drag. Still fine for a few hundred meters close range flying.
standoffs for 20x20 mount VTX. Glue in some nylon standoffs to keep the PLA from melting.
https://youtu.be/CPnI-sDjgUU
The tray clips strongly under the carbon spar and is removable anytime. Make sure the ESC wires are long enough to reach when replacing motors ore removing the tray.
Keep in mind that having all electronics so close to each other needs proper GPS to work like M8Q or M8N and also should use 2.4GHz system to not interfere with digital servos like 900MHz systems do. FPV antenna is just mounted directly and stays in the fuselage for no drag. Still fine for a few hundred meters close range flying.
standoffs for 20x20 mount VTX. Glue in some nylon standoffs to keep the PLA from melting.
https://youtu.be/CPnI-sDjgUU
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!