Funko

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Jade White Transmission Distance: 5PLA BambuLab Basic Silver Transmission Distance: 0.5PLA BambuLab Basic Red Transmission Distance: 4This print uses 5 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #7 (0.64mm) swap to Blue GrayAt layer #11 (0.96mm) swap to Jade WhiteAt layer #14 (1.2mm) swap to SilverAt layer #15 (1.28mm) swap to Jade WhiteAt layer #18 (1.52mm) swap to BlackAt layer #19 (1.6mm) swap to RedAt layer #25 (2.08mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial o