Thingiverse
Funko Pop Shelf
von 3DBarbarian
59
Downloads
25
Likes
0
Makes
Quick Funko shelf build using Tinkercad. Based the measurements off of a shelf from Ikea.
115mm X 115mm
Back set with 5mm holes for average drywall screw or can use command strips/double sided tape to adhere to wall.
Placed Funko Logo on front lip for added fun.
Based on measurements can fit about one pop in box on each shelf.
Placed 3 models in system:
1. 4-in-1 print to maximize time.
2. Single shelf print w/logo
3. Single Shelf print w/o logo
115mm X 115mm
Back set with 5mm holes for average drywall screw or can use command strips/double sided tape to adhere to wall.
Placed Funko Logo on front lip for added fun.
Based on measurements can fit about one pop in box on each shelf.
Placed 3 models in system:
1. 4-in-1 print to maximize time.
2. Single shelf print w/logo
3. Single Shelf print w/o logo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!