Thingiverse
Funko Pop Stand - Remix
door fathergoat
18
Downloads
15
Likes
0
Makes
The original model did not have a flat base when I imported it into my slicer. This caused the second layer to end up as a bridge to nowhere.
The only edit I made was to remove about .2mm from the base of the model so that it makes solid contact with the print bed.
Overall solid model and my daughter loves the idea of putting a bunch of these around the house to display her Pops. Printed a few already and they came out great. Have a print bed full of them printing now.
Well done OP!
The only edit I made was to remove about .2mm from the base of the model so that it makes solid contact with the print bed.
Overall solid model and my daughter loves the idea of putting a bunch of these around the house to display her Pops. Printed a few already and they came out great. Have a print bed full of them printing now.
Well done OP!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!