Thingiverse
Funko Pop Wall Hanger - Command Strip
door vuunderboy
2
Downloads
2
Likes
0
Makes
This is a wall hanger for a single character FUNKO POP
It is designed for use with command strips so no need to damage the wall.
There is a small lip at the bottom, which holds it in place, but does not block any of the funko pop packaging.
This is also large enough to hold a Funko in a Pop Protector too.
Feel free to print and share, but not for commercial use.
No supports or base (raft, brim, etc) needed.
It is designed for use with command strips so no need to damage the wall.
There is a small lip at the bottom, which holds it in place, but does not block any of the funko pop packaging.
This is also large enough to hold a Funko in a Pop Protector too.
Feel free to print and share, but not for commercial use.
No supports or base (raft, brim, etc) needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
