Thingiverse
Funko Pop! Wall Hex Modular Display System v2
von Luluanaki
322
Downloads
1.1k
Likes
3
Makes
### Overview
This is a newer version of my [previous design](https://www.thingiverse.com/thing:6719204).
The goal was to **hide the joints between the wall hexes** for a much cleaner finish.
This version requires printing the joints separately — a bit more work to set up, but the results speak for themselves.
---
### Assembly Recommendations
- Print shelves ahead of time and assemble everything before mounting on the wall.
- Joint tolerances are tuned for a middle ground — they may feel slightly tight or loose depending on filament used.
- **Recommended method:**
1. Insert 3 joints into one hex.
2. Place on a flat surface (floor, desk, etc.).
3. Press another hex into the joints.
- Once joined, nothing will feel loose.
- If you want an easier build with fewer parts, try the [previous version](https://www.thingiverse.com/thing:6719204).
---
### Design Intent
These displays are inspired by other designs I’ve seen online, but I wanted:
- **A sleeker look**
- **Less filamen
This is a newer version of my [previous design](https://www.thingiverse.com/thing:6719204).
The goal was to **hide the joints between the wall hexes** for a much cleaner finish.
This version requires printing the joints separately — a bit more work to set up, but the results speak for themselves.
---
### Assembly Recommendations
- Print shelves ahead of time and assemble everything before mounting on the wall.
- Joint tolerances are tuned for a middle ground — they may feel slightly tight or loose depending on filament used.
- **Recommended method:**
1. Insert 3 joints into one hex.
2. Place on a flat surface (floor, desk, etc.).
3. Press another hex into the joints.
- Once joined, nothing will feel loose.
- If you want an easier build with fewer parts, try the [previous version](https://www.thingiverse.com/thing:6719204).
---
### Design Intent
These displays are inspired by other designs I’ve seen online, but I wanted:
- **A sleeker look**
- **Less filamen
Luluanaki veröffentlicht auch auf
4 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!