Funko pop wall mount *Command strips*

Funko pop wall mount that uses command strips to mount. Thought others could use this where screws or nails cant be used. Fits standard funko packages that are 88.9mm x 120.65mm. Template doesnt need much infill, I used 20%. As shown in the picture, use a level on top of the template. Comment for improvement recommendations or just because lol

Note 1: The templates keep the funko holder in place tightly and once the holder is stuck to the wall, remove the template by wiggling it out in the front and using your thumbs to press against the back of the holder.

Note 2: I am using 5lb command strips. I was only able to find these on Amazon (linked below). You can use larger ones as well, but you may have to cut them, or orient them differently.

Command strips: https://a.co/d/ePB9o65

Last modification: 01-19-25 (Added fillets on the rear of the vertical templates for easy placement onto reference holder)