Thingiverse
Funny Bunny - Meme Rabbit
33
Descargas
28
Likes
1
Makes
LMAO! I'm sure many of you know this bunny. I just had to make it.
Some settings need to be activated (print between wall/that I did not have set)
I will work on a more universal setting friendly print.
Until then this is what I got..
To print multi colors you need to swap out filaments at a specific Z height. Assuming youre not on a raft so it goes as so
layers.....
0 - 4.4mm = belly/mouth color
4.6 - 4.8mm = body color
5 - 5.2mm = nose/hands color
5.4 = outline
Use your method of pausing print AFTER the section is complete.
Show some makes!! I know this bunny was in so many color combinations. Lets see what you got.
Ill work on making an easier print.I will update this!
Some settings need to be activated (print between wall/that I did not have set)
I will work on a more universal setting friendly print.
Until then this is what I got..
To print multi colors you need to swap out filaments at a specific Z height. Assuming youre not on a raft so it goes as so
layers.....
0 - 4.4mm = belly/mouth color
4.6 - 4.8mm = body color
5 - 5.2mm = nose/hands color
5.4 = outline
Use your method of pausing print AFTER the section is complete.
Show some makes!! I know this bunny was in so many color combinations. Lets see what you got.
Ill work on making an easier print.I will update this!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
