Fury Edge Vape Loading Funnel

Tired of the mess while loading with your fingers ? This custom funnel i designed for my Fury edge by healthy rips, snaps into place snugly so that when your ready to pack the bowl, you won't be losing any loads all over the place.

You have to have your 3D printer dialed in with extrusion multiplier. Measuring from top to bottom ( not including the small tapered end) It should masure 1.235" with calipers for a nice clicky feel to it. you might have to tape an exacto blade to the top edge a little, so the clicking isn't so tight. :-) enjoy

Print settings:

Layer height: .1MM
Wall line count : 2
Top Layers : 6
Bottom Layers: 4
Infill : 20

Print Speed : 45 MM/S
Outer Wall: 25 MM/S

Used heated bed @ 60 Deg C.

Used Brim to hold part better on table : 7 brim line count

No supports, Might need to rotate is 90 degrees as shown on cura picture for orientation,
prints very well